Mefo mousse SCD Desert 140/80-18 pro adventure 600+ ccm
Supplier/manufacturer details
Name: Mefo Sport GmbH
Address:
Röthlein
97520
Německo
Phone: 00499723919115
- Use: Rally, adventure and large enduro over 600 cm3
- Construction: Special support grooves for greater stability and reduced rotation of the mousse in the tire
- Intended use: High load on heavy motorcycles
- Road crossings: Short crossings, maximum 130 km/h
- Manufactured in: Germany
MEFO MOUSSE SCD Desert
MEFO MOUSSE SCD Desert is a specially developed mousse for rally, adventure motorcycles and large enduro bikes used primarily off-road. Its construction is adapted to the higher loads of heavier motorcycles and short road sections between off-road stages.
MEFO MOUSSE SCD Desert specifications
Use: Rally, adventure motorcycles and large enduro bikes
Application: Primarily off-road riding
Construction: Adapted to the higher loads of heavier motorcycles
Road sections: Short road sections between off-road stages only
Limitations: Not designed for prolonged riding on asphalt
Manufactured in: Germany
Construction for heavier motorcycles
MEFO MOUSSE SCD Desert is designed to withstand the higher loads associated with heavier rally and adventure motorcycles. It is primarily intended for off-road stages and short road sections between them.
Prolonged riding on asphalt increases the operating temperature of the mousse and accelerates its wear. SCD Desert is therefore not designed for this type of use.
MEFO MOUSSE – an alternative to conventional inner tubes
MEFO MOUSSE replaces the conventional inner tube. It requires no inflation and eliminates the risk of punctures and pinch flats.
MEFO MOUSSE is developed, tested and manufactured by MEFO Sport in Germany. The products are also tested under demanding racing conditions.
Package contents
- 1× MEFO MOUSSE
- 1× original MEFO Mousse Gel for initial installation
The supplied amount of gel is intended for one complete lubrication of a single mousse.
Proper lubrication and maintenance
MEFO MOUSSE must always be adequately lubricated. Proper lubrication reduces friction inside the tyre and helps limit heat build-up in the material.
MEFO MOUSSE must always be as slippery as a slug.
Insufficient lubrication increases friction and operating temperature. It can accelerate wear and cause the material to crumble, negatively affecting the performance and service life of the mousse.
During each installation, check the condition of the mousse, clean it and thoroughly relubricate it with the original silicone-based MEFO Mousse Gel.
Manufacturer's recommendations
- Do not exceed the maximum speed of 130 km/h.
- Avoid prolonged riding on asphalt.
Proper storage
After removal, store the mousse in a dry place, away from direct sunlight and ideally at a constant temperature of up to 30 °C. Avoid prolonged exposure to high temperatures or significant temperature fluctuations.
Installation
Installing MEFO MOUSSE is more demanding than fitting a conventional inner tube and requires experience, the correct procedure and suitable tools. If you have no experience with mousse installation, we recommend using a professional workshop.
Installation warning
During installation, take care not to damage the mousse with a tyre lever or cut it against the rim edge. Such damage can cause premature deterioration of the material and significantly shorten the service life of the mousse. Use suitable tyre-fitting tools and proceed carefully.
Material: Special rubber compound developed by MEFO Sport.
Recommended additional purchase
More information about mousse
| Použití | zadní |
|---|---|
| Rozměr v palcích: | 18 |
| Typ produktu | MOUSSE |
| Vhodné pro | velké enduro |
| Terén | bláto , kámen , písek , střední , trvrdý provrch |
Our Store
Not far from Strakonice, in the small village of Jinín next to the world-famous motocross track, you'll find our MEFO store. Here, you'll always be welcomed by friendly, easy-going staff who are ready to help you throughout your visit.



